Dab-Operation - Renkforce 1574942 Bedienungsanleitung

c) DAB-operation
First scan
• After first activation of the DAB mode, the device will automatically perform a station scan in
the DAB reception range. During the search, the display information shows progress and the
number of stations found.
• After completion of the station scan, the first station in the station list is played back.
If no stations are found, no signal could be received. In this case, move the device
or align the aerial (14) differently, and perform the station scan again. Check if DAB
stations are broadcast in your area.
Station selection from the station list
• Push the buttons
• Select the desired station with the buttons
• Confirm your selection by pushing the dial switch (11).
Station memory
• The device can save up to 10 DAB stations.
• Select other DAB station to be saved as described above.
• Press and hold the button
display (12).
For empty station slots, no station name is displayed; if the station slot is already
occupied, the name of the station saved there is displayed.
• Use the button
by pushing the dial switch (11).
• To delete a saved station, just save another station on its memory slot.
Selecting saved stations
• Push the button
station.
• Confirm your selection by pushing the dial switch (11).
When no station is saved on the chosen station button, the currently set station will
continue to play.
34
(9) or (10) to show the station list in the display (12).
(8) until the list of the station memory appears in the
(9) or (10) to select the desired memory slot and confirm the selection
(8) briefly and then use the buttons (9) or
(9) and (10).
(10) to select the desired