Setting Up And Attachment Options; How To Set The Time; How To Set Countdown Time; Stop-Watch Function - Conrad 61 81 95 Bedienungsanleitung

Never leave unconsumed batteries in the Countdo-
wn Timer. Even leak-proof batteries can corrode
and may thus release chemicals which are a health
hazard and may irreparably damage the battery
compartment. Fitting batteries the wrong way ro-
und (incorrect polarity) will irreparably damage the
Countdown Timer!
Environmentally important!
As consgggumer of the product, you are legally re-
quired (regulation relating to used batteries) to re-
turn all used batteries and rechargeable batteries
(from button cell to lead battery). Disposal in dome-
stic waste is illegal.
You can dispose of your used batteries and rechar-
geable batteries by returning them free of charge to
our facility in Hirschau, or, as previously, to local
disposal centers (recycling centers), which are obli-
ged to accept them.
Act to protect the environment!

Setting up and attachment options:

The Countdown Timer can be attached by the clip provided,
suspended, rested on its stand (12) and magnetically attached.
Make sure that the Countdown Timer is firmly secured, be-
cause it may be irreparably damaged if it is dropped.

How to set the time:

Press the clock button (4) for approx. 3 seconds until a short
acknowledgment signal becomes audible and the time display
(3) starts to flash.
8
Use the round adjustment knob (2) to set current time. The
knob can be turned in both directions. The AM/PM display (6)
indicates whether the time set is AM or PM.
To save the time you have set, press the clock button (4) once.

How to set countdown time:

Press the timer button (5) once.
Use the round adjustment knob (2) to set the desired countdo-
wn time.
To start the countdown time, press the button Start/Stop (1)
once. The countdown time can be interrupted by pressing the
Start/Stop button and then continued.
When the countdown time is over (00:00), an acoustic signal is
audible for 1 minute. The display also shows the time after the
acoustic signal.
To interrupt the acoustic signal, you must press the Start/Stop
button (1). The display then shows again the countdown time
set.

Stop-watch function:

Press the timer button (5).
Use the round adjustment knob (2) to set the countdown time
to 00:00.
To start/stop the stop-watch function, press the Start/Stop but-
ton (1).
Countdown time can be set at 1 minute intervals.
9