Description Of Components; Operation; Fitting/Replacing The Battery - Conrad 61 81 95 Bedienungsanleitung

Description of components

1
2
START
STOP
:
PM
3
5
4
1. Start/Stop button
2. Round adjustment knob
3. Time display
4. Clock button
5. Timer button
6. AM-PM display
6
7
6
8
12
7. Housing screw
8. Battery compartment
9. Attachment magnet
10. Acoustic signal opening
11. Attachment clip
12. Stand

Operation

Important:
Before starting to operate, please read carefully the section re-
11
lating to regulation use of the device, and also the Notes on
Safety and technical data.
1
Fitting / replacing the battery:
After some time, the acoustic signal becomes weaker or the time
9
display is difficult to read: time to replace the battery.
This is what you do:
Using a suitable cross-head screwdriver, loosen the three screws
of the housing (7) and carefully remove the housing cover. Replace
the used microcell with a new one of the same type.
When fitting the battery, make sure it is the right way round
(polarity). See figure showing components!
Important:
If after fitting the battery, a continuous beep is audible, and all
display elements light, you need to remove the battery, refitting
it after a waiting period of approx. 10 seconds. Replacing the
battery deletes all settings. In this way, you are able to comple-
te a RESET!
Replace the cover of the housing and re-attach the cover using the
three housing screws (7).
Make sure not to tighten the screws too much (you should feel
when the screws are tight enough).
7