EN
ONE UR
Assembly
1
4
!
ATTENTION!
Following steps must be
done in order as described
necessarily!
14
Urinal control
2
5
1.
Make a pre-flush.
2.
Close shut-off valve. Insert dirt filter.
Then disconnect water supply and power supply. Only
reactivate until ceramic urinal is mounted.
3.
Insert magnetic valve with seal. Attention! Follow flow
direction of magnetic valve. Open shut-off valve.
4.
Connection cable 2-pin (2 x 0.5 mm) to collect sensor.
5.
Infrared sensor must be connected. Any polarity.
6.
Attach micro sensor.
SanTec MICRO ONE
3
6