Connections, Operating And Display Elements; Led Display - Cameo ROTOFEVER CLRF Bedienungsanleitung

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

6
1
POWER IN
IEC mains socket with built-in fuse holder. A suitable IEC power cable is included.
IMPORTANT: Replace the fuse only with a fuse of the same type and value. In the event of repeated fuse failure, please contact an authorised
service centre.
2
POWER OUT
IEC power output socket. Facilitates power supply to other CAMEO lights. Ensure that the total current consumption of all connected devices
does not exceed the value specified on the device in amperes (A).
3
DMX IN
3-pin male XLR socket for connection to a DMX control device (e.g. DMX console).
4
DMX OUT
3-pin female XLR socket for sending the DMX control signal.
5
IR
Infrared interface on the front and back. Controlling the effects spotlight with the infrared remote control supplied. Ensure that the infrared
interface of the remote control is positioned within eight metres of the effects spotlight, directly in line with one of the infrared sensors.
6
EYELET FOR SAFETY CABLE
Overhead installation may only be carried out by qualified personnel. The spotlight must be fitted with a suitable safety rope to ensure that it
does not fall down.
5
7

LED DISPLAY

The four-digit LED display shows the operating mode and other system information.
2 1
7
8
9
12
4
5
3
13
10
11
14
5