Device Elements; Start Up; Dry Vacuum Cleaning - Kärcher NT 35/1 Tact Bs Originalbetriebsanleitung

Device elements

1 Electrodes
2 Suction hose (not included in the deliv-
ery)
3 Cable hook
4 Air outlet, working air
5 Suction head lock
6 Wheel
7 Air inlet, motor cooling air
8 Dirt receptacle
9 Steering roller
10 Suction head
11 Suction support
12 Floor nozzle (not included in the deliv-
ery)
13 Suction pipe (not included in the deliv-
ery)
14 Steering roller bow (NT 55/1 only)
15 Carrying handle
16 Filter cover
17 Push handle (NT 55/1 only)
18 Holder for suction pipe
19 Elbow (not included in the delivery)
20 Automatic filter dedusting
21 Main switch
22 Flat fold filter
23 Filter dedusting
24 Holder for floor nozzle or oven nozzle
25 Power cord
26 Nameplate

Start up

Caution
The flat pleated filter must always be in
place while vacuuming.
Anti-static system
Static charge is deflected by providing
earthing to the connection nozzles. This
prevents the formation of sparks and cur-
rent shocks due to attachments (option)
with electrical conductivity.

Dry vacuum cleaning

To suck fine dust, you can also use an
–
additional membrane filter (optional).
Installing membrane filter (optional)
Illustration
 Release and remove the suction head.
 Pull the membrane filter over the con-
tainer edge.
 Insert and lock the suction head.
Wet vacuum cleaning
Remove the membrane filter.
Illustration
To suck wet dirt, always remove the
–
membrane filter.
General
If wet dirt is vacuumed with the uphol-
–
stery or crevice nozzle, or if water is
sucked up from a container, it is recom-
mended to deactivate the "automatic fil-
ter cleaning" function.
If the maximum liquid level is reached
–
the appliance will turn off automatically.
In case of non-conductive liquids
–
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
When suckung up oil or grease-contain-
–
ing liquid, we recommend installing the
upgrade kit for non-conducting media,
order no. 2.641-560.0 (optional).
After the wet vacuuming: Clean the flat
–
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.
Clip connection
Illustration
Many suction hoses (optional) are
equipped with a clip system. All C-35/C-
DN-35 accessories can be connected.
– 2
EN 13