Teaching; Operation; Resetting To Factory Status - HomeMatic HM-LC-Dim1L-CV Installations- Und Bedienungsanleitung

7.2 Teaching

Please read this section completely before starting
with any teaching!
Both devices to be connected are set to teach mode
for teaching. The actuators have no special teach
button. Hold the channel button on the actuator for at
least 4 seconds for teaching. Teach mode is indicated
by the device LED flashing continuously.
If no teaching occurs, teach mode is automatically
ended after 20 seconds. If other devices are in teach
mode, these are taught.
8

Operation

After teaching, simple operating functions are available
using the taught control elements. Brief press of the
button: ON/OFF, long button press: Dim. The following
behavior results in this case:
32
Button
Brief button press
"ON" button
Brief button press
"OFF" button
Long button press
"ON" button
Long button press
"OFF" button
9

Resetting to factory status

In order to reset the actuator to factory status, switch
the device to teach mode with the (first) channel button
(hold button pressed for at least 4 seconds). If the
device is in teach mode, hold the (first) channel button
pressed down for at least 4 seconds. The actuator
reset is indicated by the device LED flashing quickly.
Behavior
ON
OFF
Brighter
Darker
33