Function - HomeMatic HM-LC-Dim1L-CV Installations- Und Bedienungsanleitung

Operating the device is only permitted with a 230 V/50
Hz alternating current network. Work on the 230 V
network is only permitted by qualified electricians (in
accordance with VDE 0100).
Always observe the applicable accident prevention
regulations.
Disconnect the power to devices before working on
them to prevent electrocution (switch circuit breaker).
Ignoring installation instructions can cause fires or
other hazards. This device is to be operated indoors
only and keep away from the influences of humidity,
dust and sunshine or other radiating heat sources.
Make sure to observe the applied load! The dimmer
is only suitable for light bulbs and for low voltage NV
halogen lamps with conventional transformers!
The devices are not intended to be isolated. The load
is not electrically isolated from the mains.
Fuse every transformer on the primary side according
to the manufacturer's specifications when working with
conventional transformers.
Use only safety transformers that conform with
DIN EN 61558-2-6 (VDE 0570 part 2-6).
24
Load the devices to the specified limits only. An
overload can cause destroy the device, cause fires or
electrical accidents.
Do not open the device. It does not contain any
parts to be maintained by the user.
There is a risk of electrical shock by opening
the device. Make sure that the specified
wiring and wire cross-sections are used when
connecting to device terminals.
3

Function

The actuators control connected consumers based on
the radio commands received. Commands are sent
out by actuating buttons, remote operations or from a
software interface. In addition, it is possible to control
actuators with sensors that are taught. The sensors
send (like a button) a command when an event occurs.
More information is provided in the instructions for the
respective sensor.
25