Product Programme; Connection And Operation - Migatronic FLEX2 3000 Compact Betriebsanleitung

PRODUCT PROGRAMME

2
FLEX 3000 Compact:
300A welding machine for MMA and MIG/MAG
welding. The machine is air-cooled and is supplied
with integrated trolley and built-in wire feed unit with
4-roll drive.
Welding hoses and cables
MIGATRONIC's product range can provide
electrode holders, MIG/MAG torches and hoses,
return current cables, intermediary cables and wear
parts etc.
Push pull (option)
2
FLEX 3000 Compact can be retrofitted with extra
equipment; thereby a MIGATRONIC Push Pull torch
can be connected and used.
Torch cooling (option)
When ordering the machine, an integrated cooling
module can be ordered, which enables both water-
cooled and gas-cooled welding torches to be used.
Trolley with unit for changable voltage (option)
A trolley with a built-in unit which automatically
adjusts the actual three-phased mains voltage (230-
2
500V) to the FLEX 3000 Compact.
Intelligent Gas Control (option)
Gas saving kit, which automatically adjusts the gas
flow.
Accessories
Please contact your Migatronic dealer for further
2
information on FLEX 3000 Compact accessories.

CONNECTION AND OPERATION

Permissible installation
The following sections describe how the machine is
made ready for use and then connected to mains supply,
gas supply etc. The numbers in parentheses refer to the
illustrations in this paragraph.
Dispose of the product according to local
standards and regulations. More information can
be found under Policies at www.migatronic.com
Configuration
MIGATRONIC disclaims all responsibility for damaged
cables and other damages related to welding with
undersized welding torch and welding cables measured
by welding specifications e.g. in relation to permissible
load.
Important!
In order to avoid destruction of plugs
and cables, good electric contact is
required when connecting earth
cables and intermediary cables to the
machine.
Generator use
This welding machine can be used at all mains supplies
providing sine-shaped current and voltage and not
exceeding the approved voltage tolerances stated in
the technical data. Motorised generators observing the
above can be used as mains supply. Consult your
supplier of generator prior to connecting your welding
machine. MIGATRONIC recommends use of a
generator with electronic regulator and supply of
minimum 1.5 x the maximum kVA consumption of the
welding machine. The guarantee does not cover
damage caused by incorrect or poor mains supply.
Mains connection
Before connecting the power source to the mains supply,
ensure that the power source is of the same voltage as
the mains voltage provided and that the fuse in the
mains supply is of the correct size. The mains cable (1)
of the power source must be connected to the correct
three-phase alternating current (AC) supply of 50 Hz or
60 Hz and with earth connection. The sequence of the
phases is not of significance. The power source is
switched on with the mains switch (2).
17