9.8. Selecting the settings
Tap on the
symbol to select the settings for the connected IP camera.
The following functions are available:
Wi-Fi settings
Select the network and enter the network password
Flip the image horizontally
Swipe the slide control to the right to flip the real-time image horizontally.
Flip the image vertically
Swipe the slide control to the right to flip the real-time image vertically.
Manually taking a photo/recording (only possible with a microSD card)
Swipe the slide control to the right to manually take a photo/recording.
Motion sensor
Tap on this button to select the sensitivity of the motion sensor: high, medium,
low or off.
Recordings and photos that are triggered by the motion sensor are au-
tomatically saved to the microSD card.
Device information
Information on the IP camera (hardware and software, connection data).
10. Indicator light display
The indicator light on the camera shows the status of the camera.
The indicator light ...
lights up permanently in
red:
flashes in red:
flashes in green:
lights up permanently in
green:
11. Resetting the IP camera
If the IP camera no longer responds or if problems occur with the network connec-
tion, it may be necessary to reset it to the factory settings.
Press and hold down the SET button using a thin object for approx. 10 seconds
to reset the IP camera to the factory settings.
68 of 74
No Internet connection
Network connection being established
Network connection between camera and router
successfully established, no server connection
Network and server connection established