Silent Mode; Fitting Accessories - Elinchrom ELB 1200 Pro Gebrauchsanleitung

• There is high voltage and can be high currents inside, so please apply all the usual
safety precautions when handling the unit, changing flashtubes, flash cables, etc., as
you would with mains powered electronic flash.
• Protect the heads & power pack when used in wet conditions.
• Flashhead cables must be connected correctly to the power pack
• If the unit has been exposed to very cold conditions, sudden exposure to warm or
humid air may cause condensation and malfunction.
• Transport the heads only in the original bags, cases or cartons and protect the
flashtube and the LED with the protection cap.
• Avoid direct sunlight which might heat up the heads and the power pack.
• Do not open the unit. In the event of damage or apparent failure, contact the Elinchrom
Service Centre.

SILENT MODE

The ELB 1200 heads offer ventilation cooling which can be switched to "silent mode" for
video use.

FITTING ACCESSORIES

1. Always switch the power pack off, before attaching accessories.
2. Mount the ELB 1200 head to a tripod and lock the security screw.
3. Turn the locking ring of the reflector bayonet anticlockwise to the OPEN position.
4. Insert an accessory and turn it clockwise until you hear it click into place.
5. Turn the locking ring clockwise to lock the bayonet, indicated by the white mark on the
bayonet ring.
6. Check that the reflector is properly connected.
User Manual
EN
5