What If There Are Problems; Technical Data - Beurer MC3800 Gebrauchsanweisung

leather.
Important!
• Clean the device using only the methods specified.
• Under no circumstances may liquid enter the device.
• Do not use any solvent-based cleaning products.
• Do not use aggressive cleaning products. These can damage the surface.
Folding mechanism, see above
w

8. What if there are problems

Problem
Grinding noises during
operation.
The massage cannot
be started.
Back rest and leg rest can-
not be raised or lowered.
The massage function
stops when the chair is
in operation.
Hand switch does not
work

9. Technical Data

Product description
Mains voltage/frequency
Energy consumption
Dimensions (in flat position)
Weight
Maximum load capacity
Cause
These noises are normal and
originate from the operating mo-
tor or from the massage rollers
rubbing against the cushion.
The mains plug is not connected
to the socket.
The massage chair is not swit-
ched on at the main switch.
The cutout switch for the mas-
sage chair has interrupted the
power supply.
Back rest and leg rest are over-
loaded or blocked.
The overheating protection was
triggered.
The maximum operation period
was reached.
Hand switch is not configured to
the massage chair
Massage chair MC3800
220-240 V ~ 50/60 Hz
150 W
Length 162 cm, width 73 cm, height 76 cm
Net 50,5 kg, with packaging 60,4 kg
150 kg
Solution
No action is necessary.
Plug the mains plug into the socket.
Switch on the massage chair at the main switch.
In this case, please contact Customer Service.
Remove the objects blocking the device.
Switch off the massage chair and allow to cool
down for 30 minutes before switching on again.
To configure the hand switch, point it towards
the bottom half of the back rest. It should be no
more than 40 cm away.
Press the On/Off button on the hand switch until
the LED above the relax massage programme
lights up. After approximately 3-4 seconds, LED
4 starts to flash and then switches off. The hand
switch is now configured and ready for use.
22