Safety Regulations; Layout And Items Supplied - EINHELL BT-BD 801 E Originalbetriebsanleitung

Important!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Caution!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
1.1 Special instructions for the laser
Important: Laser radiation
Do not look into the beam
Laser class 2
VORSICHT ! - LASERSTRAHLUNG !
Nicht in den Strahl blicken!
Laserspezifikation
Laser Klasse 2; RLM-08
: 650 nm; P
0
•
Never look directly into the laser path.
•
Never direct the laser beam at reflecting sur-
faces or persons or animals. Even a low out-
put laser beam can inflict injury on the eye.
•
Caution: It is vital to follow the work proce-
dures described in these instructions. Using
the equipment in any other way may result in
hazardous exposure to laser radiation.
•
Never open laser module.
Anl_BT_BD_801_E_SPK1.indd 23 Anl_BT_BD_801_E_SPK1.indd 23
GB
•
When the pillar drill is not going to be used
for an extended period of time, the batteries
should be removed. It is prohibited to carry
out any modifications to the laser to increase
its power.
•
Do not make any modifications to the laser
that are designed to increase the laser's
power.
•
The manufacturer cannot accept any liability
for damaged caused by a failure to comply
with the safety information.

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. Machine base
2. Pillar
3. Roller support
4. Drill table
5. Drill table clamp shaft
6. Machine head
7. V-belt
8. Motor
9. Grip knobs
10. Drill chuck
11. Spindle
12. Mounting holes
13. Folding chip guard
14. Depth stop
15. Speed control lever
16. Screw
17. Digital display
18. ON switch
19. OFF switch
20. ON/OFF switch (laser)
27. Drill chuck
- 23 -
02.08.12 11:22 02.08.12 11:22