Error Messages - sylvac Hi-Cal 300 Bedienungsanleitung

19 Error messages

Err0
Sensor measuring error. Press SET , and control the measuring reference
Err1 Parity Error (RS232 | USB connexion)
Err2 Unkown command (RS232 | USB connexion)
Err6 Error during the probe measuring detection sensor procedure. In case of
a problem during Hall initialization, please proceed with following
controls:
- Is the probe free to move ?
- Is the measuring force correctly set (see also chapter 17) ?
- If REF1 and CMDE are displayed, paddles may have been activated during
the initialization procedure. Please check that the paddles are free.
Err7
Possible action on the Keypad or FCT key during initialization. Please check
that keypad and FCT are free, then restart the Hi_Cal.
REF1 paddles may have been activated during the initialization procedure. Please
CMDE check that the paddles are free, and restart the Hi_Cal.
53