Fct Key Used In Diameter Mode; Measuring Using Hi_Cal; Constant Setting - sylvac Hi-Cal 300 Bedienungsanleitung

The different settings are:
FCT1 data output
FCT2 zero setting
FCT3 preset recall
FCT4 surface ↔ Dia
FCT5 surface ↔ Min
FCT6 clear Min | Max
FCT7 Ref 1 ↔ Ref 2
FCT8 Low ↔ High
FCT9 measure ↔ Diff

10. FCT key used in diameter mode

In diameter measurement, the FCT key can be used instead of the rear paddles to drive
the probe from the 1st measurement point to the 2nd measurement point. This is most
useful for measuring small diameters.
1. 1st meas. point
At the end of a diameter measurement, the FCT key will release the probe from its contact
point to be ready for other measurements.
As soon as the probe looses contact with the part, the FCT key recovers its former setting
(for instance: data output).

11. Measuring using Hi_Cal

Use the paddles on the back to move the probe UP and DOWN, until the probe is on
contact with the first surface.

11.1 Constant setting

Before beginning new measurements, we recommand to control and enter (if necessary)
the probe constant value. The probe constant value must be set correctly in case of shaft
or diameter measurements, this because the Hi_Cal will take account of the probe
constant, i.e. the diameter of the ball probe and its deflection when measuring reversed
surfaces.
The master gauge supplied with the Hi_Cal must be used to measure the probe constant.
46
: sends displayed value to RS232 and USB
: zero setting (even if a preset has been entered)
: preset value recall
: toggles between surface and diameter mode
: toggles between surface and Min | Max mode
: initializes Min and Max value to probe position
: toggles ref1, ref2
: toggles between High and low speed ranges
: difference between the 2 last measurements
2. Action on FCT key
Press the CST key and touch one of the ground surfaces of the
cylindrical gauge. Release the probe and touch the opposite
surface. The probe constant value is displayed and memorized
until a new constant value is taken.
3. 2nd meas. point
4. Action on FCT key