Changing The Probe; Adjusting The Cursor Balance; Replacing The Batteries - sylvac Hi-Cal 300 Bedienungsanleitung

16. Changing the probe

The Hi_Cal enables the use of different probes and accessories. To change the probe,
simply unscrew the lever and insert the new probe.
Important: - Check if the eccentric probe is correctly positionned
- Clamp it firmly
- Make sure to use probes with weight value compatible with the weight
adjustement selector
The probe constant must be checked after any probe change or modification of the probe
position.
The Hi_Cal cursor has been balanced for a standard 2mm ball probe. For heavier probes
such as depth measuring probes, the cursor balance must be set in the UP position.

17. Adjusting the cursor balance

The weight adjustement selector enables two different setting:
UP : balance setting for
heavier probes (depth,
90° , extended measuring
probe for instance)
DOWN : standard probe
weight setting
Use a ball pen or a small screwdriver to move the balance selector into correct position

18. Replacing the batteries

Unscrew the fixing screw at the rear of the Hi_Cal base and remove the battery cover |
ergonomic handle to change batteries.
Important: please only use NiMH rechargeable battery pack delivered by Sylvac for battery
replacement.
52