Instructions For Use; Cleaning; Descaling; Maintenance & Spare Parts - NUK Baby Menu Bedienungsanleitung

3.1 CLEANING

The removable parts must be cleaned
thoroughly before first use and after each
subsequent use. The device must first be
disconnected from the power supply. Allow
it to cool down before you begin cleaning.
To descale the
described in section 3.2.
Risk of electric shock! An electric
current passes through the base unit
22
during operation. Never immerse the
appliance in water.
Always allow the appliance to cool
down before cleaning.
23
Clean the base unit with a damp sponge or
cloth. Dry it with a lint-free cloth.
Do not clean the base unit in the
dishwasher.
24
Clean the removable parts in the dishwasher
or using a damp sponge or cloth in
conjunction with a detergent solution.
When cleaning the device, do not use
scourers,
25
aggressive liquids such as benzine or
acetone.
To clean the hot steam duct in the lid, we
recommend that you occasionally rinse the
lid under running water directly after use. If
the duct cover should become blocked, it
can be removed from the lid (Figure 15). The
duct cover should then be replaced in the lid
after cleaning and drying.
After cleaning and drying, ensure that
a blade and the seal are correctly re-
26
installed.
Note: See section 2.2.1 for instructions on
fitting the blades.

3.2 DESCALING

Over time and depending on the water qua-
lity, limescale deposits may form at the bot-
tom of the water reservoir. You should
descale your device as soon as these

3. INSTRUCTIONS FOR USE

device, proceed
abrasive cleaners
appear, but at the latest every 20 heating
cycles. This is necessary in order to prevent
limescale particles blocking the hot steam
ducts and to ensure correct heating of the
water.
Before descaling your device, ensure that it
is switched off and disconnected from the
as
power supply.
You should descale your device at regular
intervals, depending on the water hardness
in your region. To do so, fill the water
reservoir with 100 ml of table vinegar
followed by 100 ml of boiling water. Allow
the solution to work for a maximum of
30 minutes (ensure that the mains plug is
disconnected). Empty the water reservoir
over the side, as shown in Figure 16. Rinse
out the tank with fresh water. Ensure that no
liquid enters the base unit when filling and
emptying the water reservoir.
Do not use any commercial desca-
lers, especially not ones containing
27
citric acid.
When descaling, do not leave the
vinegar solution in the device for
28
more than 30 minutes. Otherwise you
or
may damage the device.
3.3 MAINTENANCE & SPARE
PARTS
Regularly check the device for damage
before use. Particular attention should be
paid to the integrity of the seals and sound
condition of the power cable. Please also
refer to section 4 in the event of a problem.
Never use a defective device or a
device with defective accessories.
29
Note: Store replacement seals in a safe
location, where they are readily retrievable!
Damaged parts must be replaced with
genuine spare parts. Complaints should be
directed to the relevant contact address for
your country. The warranty will be rendered
void by independent repairs to the device
during the warranty period as well as by the
29