Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
LOGGING ON A HANDSET TO THE 5500TECH BASE STATION
1.
Hold down the paging button,
twice. You now have 90 seconds to register the new handset.
2.
Press the
3.
Use
and
4.
Now use the number buttons to enter the number of the base station (1 - 4). If the
handset is already registered with a base station, the corresponding numbers will
blink.
5.
Press the
6.
Now enter the PIN number for the base station (factory setting, 0 0 0 0).
7.
Now press the menu button
handset is now registered and can be used for external and internal calls.
8.
An internal number will now have been allocated to the handset. The first handset
registered (main handset) has the internal number 1. Any further handsets that are
registered are allocated internal numbers (2 to 5) in the order of registration. This
internal number is shown in the display to the right of the name.
LOGGING ON A HANDSET TO ANOTHER DECT/GAP BASE STATION
SYSTEM OR A THIRD PARTY BASE STATION
1. Prepare other base station
Follow the operating instructions indicated under 'Logging on additional handsets' of the
base station you would like to log on to.
2. Logging on the 5500TECH handset
Proceed as described above, but use the PIN code of the base station you would like to log
on to (instead of 0 0 0 0).
6
button on the handset.
to select the REGISTER menu, then press
button again.
, and you will hear a beep for a few seconds. The
on the base station for 10 seconds until it beeps
.
Werbung
Inhaltsverzeichnis
