DeDietrich DOP440 Serie Betriebsanleitung Seite 43

99633781ml.qxd 07/09/04
Your oven displays the three pyrolysis symbols
pyrolysis cycle (non-adjustable)
You can select two other pyrolysis cycle lengths (
1:45, 1:30) that are non-adjustable by
turning the selector button.
The oven cannot be used for 2:00, 2:15 or 2:30.
This time includes the cooling time until the door
can be unlocked.
d) Enter the programme by pressing the selector button. The door locks
during the pyrolysis cycle (after approximately two minutes). You can check the
time at which the pyrolysis cycle should end by pressing the
At the end of the pyrolysis cycle, the
e) Turn off the oven by pressing the selector button.
f) When the oven is cool, use a damp cloth to remove the white ashes. The oven is
clean and once again ready for the cooking application of your choice. Notes: The cleaning
temperature cannot be adjusted. During the pyrolysis cycle, the oven lighting is off. If your
oven is not clean after a pyrolysis cycle, you waited to long to launch the cleaning cycle.
Repeat the cycle.
2) How do you program for delayed pyrolysis?
Follow the instructions described in the "Programming for immediate pyrolysis" section,
then
a) Press the
the pyrolysis end time flashes to indicate
that it is now possible to set it.
b) Adjust the pyrolysis end time by
turning the selector button.
Example: Pyrolysis ends at 5:00.
When the pyrolysis cycle is finished, press the selector button.
14:39 Page 43
How do you clean the cavity of your oven?
symbol id displayed until the door is unlocked
touch control,
corresponding to a two-hour
touch control.
GB
43