Description Of Control Panel - Candy FOFP827 Bedienungsanleitung

Multifunction electronic oven

DESCRIPTION OF CONTROL PANEL

The control panel has two knobs for selecting functions and two buttons for setting the ti-
me, temperature and the start/end of cooking.
NB: Some models are fitted with pop-out controls. To turn the knob, first push inwards to
release.
Clock display
22:38
1
Programme
function selector
knob
Programmer
function
display
NB:
• Never cover the oven walls with aluminium foil, as this would concentrate heat and da-
mage the oven enamel.
• Grilling should always be carried with the oven door closed.
• If the clock is not set the oven will not work and 12:00 will flash on the display.
• To cancel all set functions and times turn knob (2) to the symbol.
To start cooking a function must be selected using knob (2). The corresponding symbol
will appear on the display and the automatically pre-set temperature will flash. If you wi-
sh to alter that temperature, press the
After a few seconds the oven will start working, but the programme selector can be regu-
lated so that the start is delayed until the required time (see chapter "The Programmer").
EN
Safety
display
Temperature display
200°C
2
Oven function
selector knob (cooking)
Regulator
buttons
Cooking function
display
or buttons.
21
The cooking function symbol will flash until the oven reaches the temperature shown on
the display. When that temperature is reached it will stop flashing and an audible signal
sounds.
For details of the various cooking modes see p. 25.
The oven can be switched off at any stage by simply turning the selector knob (2) to "0".
Temperatures
The temperature is pre-set for every type of cooking function. However, it can be modi-
fied according to specific requirements, as listed in the table on p. 25. The pre-set tem-
peratures for pizzas, defrosting and keeping warm functions cannot be altered.
The display shows the pre-set temperature, which increases or decreases by 5°C each
time the or buttons are pressed.
The Programmer
Presentation
1
Programmer
function
display
Oven light
Clock regulator
Regulation of cooking time (from 0 to 3h59')
End of cooking timer control
Timer
Child safety
Regulator button
Regulator button
A slight delay will occour when setting a programme, while the oven carries out internal
diagnostics.
Safety
display
22:38
Control
buttons
22
EN