Remote Controlling Zone 2 - Yamaha RX-V757 Bedienungsanleitung

Using this unit's internal amplifier
To use this unit's internal amplifier, set "ZONE2 AMP" to "INT" in SET MENU (see page 65).

Remote controlling Zone 2

The supplied remote control can be used to control Zone
2. You can even select the input source and control
components located in the main room directly from the
second room regardless of the listening condition in the
main room.
y
You can also turn on/off the MAIN and Zone 2 mode by pressing
MAIN or ZONE 2 on the front panel.
■ To enable Zone 2 mode on the remote
control
You will be able to switch the remote control mode from
one room to another, and use STANDBY, SYSTEM
POWER, MUTE and VOL –/+ to control the selected
room.
1
Repeat steps 1 and 2 of the procedure in
"Setting remote control codes" on page 69.
2
Press j / i to select "L:AMP".
PRESET
TV VOL
CH CH
TV MUTE
ENTER
TV VOL
PRESET
3
Press u / d to select "ID1Z".
PRESET
TV VOL
CH CH
TV MUTE
ENTER
TV VOL
PRESET
Notes
• To select the Zone feature with ID2, select "ID2Z".
• Since the Zone 2 code is common to "ID1Z" and "ID2Z", the
Zone 2 code does not change even if the AMP library code
(remote control setting) is switched.
– +
L
R
PRESENCE
/ZONE 2
Second room
This unit
4
Press LEARN to complete the Zone setup.
The remote control will be able to operate this unit
and Zone 2.
■ To control Zone 2
1
Press SELECT k repeatedly to display
"ZONE2" in the display window.
2
Press SYSTEM POWER to turn Zone 2 power
on.
ZONE 2 (RX-V757 ONLY)
LEARN
SELECT
77