Programming Codes From Other Remote Controls - Yamaha RX-V757 Bedienungsanleitung

REMOTE CONTROL FEATURES
Programming codes from other
remote controls
If you want to program functions not included in the basic
operations covered by the remote control code, or an
appropriate remote control code is not available, do the
following. You can program any of the buttons available in
the component control area (see page 68). The buttons can
be programmed independently for each component.
Note
This remote control transmits infrared rays. If the other remote
control also uses infrared rays, this remote control can learn most
of its functions. However, you may not be able to program some
special signals or extremely long transmissions. (Refer to the
operating instructions for the remote control of your component.)
1
Press an input selector button to select a
source component.
A B PHONO MULTI CH IN
V-AUX TUNER MD/CD-R CD
DTV/CBL VCR 1 DVR/VCR2 DVD
2
Place this remote control about 5 to 10 cm
apart from the other remote control on a flat
surface so that their infrared transmitters are
aimed at each other.
72
5 to 10 cm
3
Press LEARN using a ballpoint pen or similar
object.
Do not press and hold LEARN. If you hold it down
for more than three seconds, the remote enters the
remote control code setting mode.
LEARN
y
Complete each of the following steps in 30 seconds.
Otherwise, the learning mode will be automatically
canceled. In this case, press LEARN again.
4
Press the button at which you want to
program the new function.
"LEARN" is displayed.
5
Press and hold the button you want to
program on the other remote control until
"OK" appears in the display window.
Flashes alternately