Recording A Source - Yamaha RX-V420RDS Bedienungsanleitung

Recording adjustments and other operations are performed
from the recording component. Refer to the instructions for
these components.
D I G I T A L
STANDBY SURROUND
/ON
BASS TREBLE BALANCE SPEAKERS
A B PROGRAM
+ +
– – L R ON OFF
PHONES
SILENT
1
Set the volume at the
minimum level.
2
Select the source you want to record.
INPUT
Front panel
3
Begin recording by the recording component
connected to this unit.
4
Play the source and then turn up the volume to
confirm the input source.
VOLUME
Front panel
34

RECORDING A SOURCE

VOLUME
D I G I T A L
RDS MODE/FREQ EON
PTY SEEK
MODE START
INPUT MODE
PRESET
/TUNING FM/AM
INPUT
EFFECT PRESET/TUNING A/B/C/D/E
EDIT
TUNING
MEMORY MODE
MAN'L/AUTO FM AUTO/MAN'L MONO
VIDEO L AUDIO R
VIDEO AUX
2
2
4
VOLUME
Front panel
or
Remote control
or
Remote control
Notes
• Do a test recording before you start an actual recording.
• When this unit is set in the standby mode, you cannot record
1,4
between other components connected to this unit.
• The DSP program and the setting of VOLUME, BASS, TREBLE
and BALANCE have no effect on the material being recorded.
• A source connected to the 6CH INPUT jacks of this unit cannot
be recorded.
• A given input source is not output on the same REC OUT
6CH INPUT
channel. (For example, the signal input from VCR 1 IN is not
output on VCR 1 OUT.)
• Check the copyright laws in your country to record from records,
CDs, radio, etc. Recording of copyrighted material may infringe
copyright laws.
If you play back a video source that uses scrambled or
encoded signals to prevent it from being dubbed, the
picture itself may be disturbed due to those signals.