Troubleshooting; Replacing The Oven Light Bulb; After-Sales Service; E Number And Fd Number - Bosch HBX33R51 Gebrauchsanleitung

Troubleshooting

Malfunctions often have simple explanations. Please read the
following notes before calling the after­sales service.
Problem Possible cause Notes/remedy
The appliance Circuit breaker
does not work. faulty.
Power cut
The oven can- The electronics
not be switched are faulty.
off.
The clock dis- Power cut
play flashes.
The oven does Circuit breaker
not heat up. faulty.
The function
selector has not
been set.
The door glass
is broken.
Fruit juice or Moist cake or
albumen stains meat juices.
on enamelled
surfaces.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Incorrect repairs may result in significant risk to the user.

After-sales service

Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.

E number and FD number

When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate containing these numbers
can be found on the right-hand side of the oven door. To save
time, you can make a note of the number of your appliance and
the telephone number of the after-sales service in the space
below, should it be required.
E no.
After-sales service O
Please note that there will be a fee for a visit by a service
technician in the event of a malfunction, even during the
warranty period.
24
Look in the fuse box and
check that the circuit
breaker for the cooker is in
working order.
Check whether the kitchen
light works.
Switch off the circuit
breaker. Contact the after-
sales service.
Reset the clock.
Check the circuit breaker
and replace if necessary.
Set the function selector.
Switch off the appliance.
Contact the after-sales ser-
vice.
Harmless change in the
enamel, cannot be
removed.
FD no.

Replacing the oven light bulb

If the bulb in the oven light fails, it must be replaced.
Replacement heat-resistant bulbs can be obtained from the
after-sales service or from specialist retailers. Please supply
your appliance's E number and FD number. Do not use any
other type of bulb.
Switch off the appliance at the circuit breaker or pull out the
1.
mains plug.
Open the appliance door.
2.
Lay a tea towel in the cold cooking compartment to prevent
3.
damage.
Unscrew the glass cover from the defective oven light bulb
4.
inside the cooking compartment by turning it anti-clockwise.
Replace the oven light bulb with one of the same type.
5.
Voltage: 240 V;
Power: 25 W;
Thread: E14;
Temperature resistance: 300 °C
Screw the glass cover of the oven light bulb back on.
6.
Remove the tea towel and switch the circuit breaker back on
7.
or plug in the mains plug.
Press the function button for the oven lighting until it locks into
place in order to check whether the oven lighting is working
properly.
You can find the contact information for your nearest after-sales
service in all countries here or in the attached after-sales
service directory.
Repair order and advice if faults occur
0810 240 260
A
01801 22 33 55
D
(€0.039/min. from a landline,
max. €0.42/min. from a mobile phone)
0848 840 040
CH
Put your trust in the expertise of the manufacturer. You can then
be sure that the repair work is carried out by trained service
technicians who can supply original spare parts for your
household appliance.