Catalytic Cooking Compartment Panels; Removing The Ceiling Panel; Removing And Fitting The Appliance Door; Cleaning The Hook-In Racks - Bosch HBX33R51 Gebrauchsanleitung

Catalytic cooking compartment panels

The catalytic cooking compartment panels are coated with self-
cleaning enamel.
The surfaces clean themselves while the oven is in operation.
Larger splashes will only be removed after the oven has been
used several times.
Self-cleaning surfaces
The side walls are covered with catalytic panelling. Never clean
these surfaces with oven cleaner. Slight discolouration of the
enamel does not affect automatic self-cleaning.

Removing the ceiling panel

For ease of cleaning, you can remove the ceiling panel.

Removing and fitting the appliance door

You can remove the appliance door to clean it more
thoroughly.
Removing the appliance door
:
Risk of injury!
Whenever the hinges are not locked, they snap shut with great
force. Make sure that, when unhooking the oven door, the
locking levers are folded up completely.
Open the oven door completely.
1.
Fold up the left and right locking levers. Make sure that, when
2.
the locking levers are folded up, you do not close the oven
door. The hinges may become bent which may cause
damage to the enamel.
Open the oven door at an angle. Hold it on the right and left
3.
with both hands. Close it just a little further and pull it out.
Fitting the appliance door
When hooking in the oven door, ensure that the notch on the
1.
bottom of the hinge locks into the slot.
Fold down both locking levers on the left and right again and
2.
close the oven door.
:
Risk of injury!
Do not reach into the hinge if the oven door falls out
unintentionally or a hinge snaps closed. Call the after­sales
service.

Cleaning the hook-in racks

You can remove the hook-in racks for easier cleaning.
The hook-in racks in each case are fixed to the side walls of the
cooking compartment at three points.
Removing the hook-in racks
Lift the front hook out of the hole.
1.
Pull the hook-in rack forwards out of the rear holes.
2.
Cleaning the hook-in racks
Clean the hook-in racks with washing-up liquid and a sponge or
brush.
Inserting the hook-in rack
Insert the hook-in rack into the holes in the back wall.
1.
Hook the front hook into the hole.
2.
23