SEVERIN BA 3239 Gebrauchsanweisung Seite 7

Dear Customer,
Before using the appliance, please read the
following instructions carefully.
Connection to the mains supply
The appliance should only be connected to
an earthed socket installed in accordance
with the regulations.
Make sure that the supply voltage
corresponds with the voltage marked on the
rating label.
This product complies with the directives
which are binding for the CE-labelling.
Familiarisation:
1. Housing
2. Soleplate
3. Indicator lamp
4. Temperature control knob
5. Power cord
6. Base stand (rear)
Important safety instructions
●
Do not leave the iron unattended while
connected or on an ironing board.
Always remove the plug from the wall
socket when leaving the working area.
●
This appliance is not intended for use by
any person (including children) with
reduced physical, sensory or mental
capabilities, or lacking experience and
knowledge, unless they have been given
supervision or instruction concerning the
use of the appliance by a person
responsible for their safety.
●
Children should be supervised to ensure
that they do not play with the appliance.
●
The iron operates at very high
temperatures. Do not touch any part of
the appliance except the handle. Burns
can occur from touching the hot parts of
the housing or the soleplate. When
operating the iron, hold only by the
handle.
●
Do not allow the power cord to touch
Iron
hot surfaces.
●
Always remove the plug from the wall
socket after use, and also
- in case of any malfunction and
- during cleaning
●
When removing the plug from the wall
socket, never pull on the power cord. Do
not let the power cord hang free.
●
The iron must be used and stored on a
stable and durable surface only.
●
With the iron placed on its base stand,
ensure that this too is on a stable and
durable surface.
●
Do not use the iron if it has been
dropped onto a hard surface or if it shows
any other sign of damage.
●
In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The addresses can be found in the
appendix to this manual.
●
No responsibility is accepted if damage
results from improper use, or if the
instructions are not complied with.
●
If the iron is passed to another person,
this instruction manual must accompany
it.
Operation
Start up
Place the iron upright on its base stand,
insert the plug into the wall socket and set
the infinitely adjustable temperature control
knob to its ••• position.
Leave the iron connected for a short while
after the indicator lamp has gone out. This
will lessen the smell typically encountered
when first switching the iron on.
Please ensure sufficient ventilation.
Afterwards, clean the iron according to the
instructions given in the paragraph "General
Care and Cleaning".
7