Noises; Vertical Ironing; Detachable Ironing Rest; Auto-Stop Function - TurMix VX 200 Bedienungsanleitung

.11 Noises

In order to ensure a uniform steam output, your steam generator is fitted
with a pump. This becomes noticeable as soon as you press the steam trig-
ger of the iron 0.
Under certain conditions, it is louder, for example
- when the appliance is used for the first time
- the water tank is empty
- every time the anti-scale cartridge is replaced.
0
.1 Vertical ironing Your iron can also be held vertically to steam clothing on hangers or curtains
in situ etc. In this manner, you can also iron or freshen festons, trousers etc.
The results vary according to the type of fabric.
For vertical ironing, move the iron from the top to the bottom and briefly
press the steam trigger several times.
Tip: Hand the feston or trousers on a hanger for more convenient ironing.
1
.1 Detachable ironing rest
The ironing rest can be removed. It can thus be used as an ironing rest on
the ironing table, for example, for pressing shirts.
Simply pull the ironing rest upwards and backwards to release it from the
steam generator . Caution: The ironing rest is wet during and after use!
Place the ironing rest on the ironing table and put the iron on the grey silicon
stripe of the ironing rest. Ensure firm seating of the ironing rest!
  Put the ironing rest back on the steam generator:
Push the ironing rest carefully on the runners completely back into the hous-
ing . Ensure firm seating of the ironing rest, so that the iron cannot fall
down.
!
!
Caution! Wear gloves when removing or replacing the iron-
ing rest when the appliance is hot!
54 54
.14 Auto-Stop function
4
.15 After Ironing
5 6
.16 Maintenance and Care
7
The Auto-Stop function switches off the electrical supply to the appliance
automatically if
– for a period of about 20 minutes the iron has not been moved or
– the steam trigger has not been pressed for a long time.
The red "AUTO-STOP"-indicator lamp glows as soon as the function is active
4.
Upon pressing the steam trigger, this indicator lamp goes off and the appli-
ance starts to heat up again. As soon as the appliance is ready for operation,
an audio signal is sounded.
After the ironing, switch off the station with the on/off switch 5. The green
power on and the yellow steam generator light go off.
Pull the mains supply plug and let the station cool completely.
Store the cord under the cord clip 6.
Tidy up the station without emptying the tank.
Caution! Store the appliance flat, since otherwise, water
!
can run out! Do not store the appliance at temperatures
below 5 °C and keep it out of reach of children!
!
Detergent residues, or the apprets of the fabrics and materials can stick to i
the iron soleplate, so that it will not slide smoothly over the materials any
more.
Therefore, after ironing, rub off the iron with a non-fibrous cloth. Treat stub-
born stains and deposits with an iron cleaning pencil. Do not use alkali-con-
taining products (for example oven cleaners) like scouring powders, strong
cleaners, or steel wool.
55
D
FR
IT
EN