Connecting; Switching On And Heating-Up; Phase; Variable Steam Control Knob - TurMix VX 200 Bedienungsanleitung

.7 Connecting

Connect the mains cable to a grounded mains socket 10.
!
!
10
i
.8 Switching On and Heating Up Press the on/off switch 11.

Phase

The green power on lamp and the yellow steam generator indicator lamp of
the generator will glow 1.
11 1
Turn the variable steam control knob to the middle 1.
Wait till the appliance is ready for operation (when it is ready, an audio signal
is sounded) 14.
1 14
Lift the iron and hold it in the air and press the steam trigger till steam starts
to come out. When the appliance is used for the first time, this takes up to 30
seconds 15.
!
As long as the yellow steam generator indicator lamp glows 1 (about 2
min.), the steam output quantity remains at a reduced level. When the indica-
!
tor lamp goes off, it automatically increases.
i
15
Caution! Electrical energy can be fatal! In an emer-
gency, immediately pull the plug from the socket. Never
allow live parts to come in contact with water!
During ironing, the yellow steam generation indicator lamp
and the red heating-up lamp of the iron go on and off regu-
larly: This indicates that the generator and iron are getting
heated. This is a normal feature.
5 5
.9 Variable steam control knob
16
17
18
.10 Generating steam/Steam trigger
19
The flow control knob can be used to adjust the quantity of steam continu-
ously depending on the material (also see the table on page 9).
Continuous variable steam output 16:
Adjust the flow control knob to suit the type of material being ironed, to the
desired position. The table on page 9 shows typical applications. The more
you rotate the knob clockwise"+", the greater does the quantity of steam
output become.
"E" = Eco-Mode 17 (only model VX 50):
This setting is recommended for quick ironing jobs that need less steam (for
example, when you want to straighten out a slightly creased blouse early in
the morning).
"Maxi"-Modus / Turbo steam 18 (only model VX 50):
In this position, lots of steam comes out of the base of the iron for a few
seconds (= "Turbo-steam"); thereafter, the steam output quantity is reduced
back to the normal level.
Wait for a few seconds before you repeat this turbo-effect, since otherwise,
water can come out of the base (the steam has to get heated up again first).
Press the steam trigger to get steam 19.
Here are a few valuable tips for using the appliance:
Owing to the high steam output, press the steam trigger only briefly
1.
only once. Brief and repeated pressing of the steam trigger is enough to
continuously get an adequate quantity of steam (pressing it for too long can
result in water being ejected).
When use is intensive, steam can come out even after releasing the
2.
steam trigger. Therefore, the residual steam can condense on the ironing rest
and water residue is left behind. This is normal. Sponge it off if necessary.
There is no risk of the metal being damaged.
Turn the flow control knob to the middle 17:
3.
- the appliance is used for the first time,
- if the water tank is empty,
- every time the anti-scale cartridge is replaced.
Caution!
If there is no more water in the tank do not press
!
the steam trigger any more!
!
5
D
FR
IT
EN