Setting Into Operation; Inserting Batteries Into The Microphone And Remote Control - Omnitronic WAMS-08BT Bedienungsanleitung

8

SETTING INTO OPERATION

Inserting Batteries into the Microphone and Remote Control

1
For operation, the microphone requires two 1.5 V AA batteries.
Remove the cover of the battery compartment and insert two
batteries as indicated in the compartment. With new batteries,
the microphone can be operated for approx. 13 hours.
2
The remote control of the audio player is supplied with a
battery inserted. An insulating foil between the battery and the battery contacts prevents the battery
from being discharged during storage. Prior to the first operation remove the foil from the battery
support on the rear side of the remote control. Otherwise operation of the remote control is not possible.
If the range of the remote control decreases (3 meters as a maximum), replace
the battery. For this purpose, on the rear side of the remote control press the
small bar with the groove to the right and at the same time remove the battery
support.
3
If the devices are not used for a longer period (approx. 1-2 weeks), please remove the batteries to
prevent damage in case of battery leakage. Please refer to further explanations in chapter Safety
Instructions.
Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and
should not be disposed of with regular domestic waste!
Switching on the Amplifier and the Wireless Microphone
1
Insert the supplied antenna into the BNC jack ANTENNA and put it in a vertical position
2
Prior to switching on, turn down all level controls of the input channels and the effect control to the left
stop position to avoid a possible switching-on noise.
3
First switch on the connected audio sources, then the PA system. The power indicator POWER lights
up. After operation, switch off the PA system first.
4
Prior to operating the PA system off mains for the first time, the rechargeable battery must be fully
charged (→7).
5
To switch on the microphone, set the sliding switch to its upper position "ON". The power indicator
lights. If it fails to light up, new batteries must be inserted. If the reception of the radio signal is of
sufficient power, the reception indicator RF on the PA system lights up. Adjust the desired volume of the
audio signal received with the control WIRELESS MICROPHONE. To mute the microphone during
operation, set the sliding switch to its center position "MUTE". Then no sound will be transmitted.
For optimum receiving:
• maintain a line-of-sight between the microphones and receiver antennas.
• make sure the distance between the microphones and the receiver is not too long.
• make sure the reception is not disturbed by objects in the transmission path; avoid placing the
microphones and the receiver where metal or other dense materials may be present and computers or
other HF-generating equipment (min. 50 cm distance).
• make sure the batteries of the hand-held microphone are always sufficiently charged.
CAUTION!
34