Omnitronic WAMS-08BT Bedienungsanleitung Seite 28

Intensity control
Adjusts the intensity of the internal echo
effect applied to channels 1 and 2.
Link output
6.3 mm jack to feed the mixed signal (mono)
to units with line level inputs, e.g. another PA
system.
Tone controls
Controls for the high range (TREBLE) and
the low range (BASS) for the mixed signal.
Level control
To mix the signal of the audio player to the
master signal.
Power input
Used to plug in the supplied power cord.
Fuse holder
Only replace the fuse when the device is
disconnected from mains. Only use fuses of
the same rating and power.
Power on/off
Input DC IN 12V
For alternative power supply from a 12 V
source with low-voltage plug.
Battery capacity indicators
• green LED lights: battery fully charged
• yellow LED lights: power supply sufficient
• red LED lights : battery exhausted
Charging indicator
• lights red: battery is being charged
• lights green: charging completed
Power indicator
Clip indicator
The PEAK LED lights if the internal power
amplifier section is overloaded. Reduce the
volume of the signal sources accordingly.
Memory card slot
USB port
LCD
Infrared sensor for the remote control
PLAY and PAUSE [►II]
For switching between play and pause.
NEXT [ ], PREV [ ] and VOL+ [+],
VOL- [-]
• short actuation: for title selection
• long actuation: for volume adjustment
PRT [ENTER] and EQ [EQ]
• short actuation: for selecting random play
and repeat functions
• long actuation: for selecting equalizer
settings
MODE [MODE]
For switching between the data carriers USB
and SD and Bluetooth operation.
STOP and POWER
• short actuation: stops the playback
• long actuation: switches the audio player on
and off
Buttons [0-9] and [PICK SONG]
Numerical keys for direct selection of a title.
28