Setting Into Operation - Omnitronic OD-5A Bedienungsanleitung

6

SETTING INTO OPERATION

Switch off the speaker system and the units to be connected before making or changing the connections.
1
For connecting the signal source, three inputs are available. Use the RCA jack or the 3.5 mm jack for
unbalanced signals and the spring terminals for balanced signals. It is possible to connect the line
output of e.g. a mixer, CD player or computer. The different inputs are provided to allow for flexible
connectivity and not for connecting multiple sources to your speaker simultaneously. When several
jacks are used at the same time, the input signals are mixed.
Model OD-5A does not have a 3.5 mm jack input.
2
Finally, connect the supplied power supply cable to the corresponding input and the mains plug to an
outlet.
3
Switch on the signal source connected.
4
Prior to switching on, turn the LEVEL control to the left stop position to avoid a possible switching-on
noise.
5
Switch on the speaker system with the power switch. The POWER indicator lights up.
6
Adjust the desired overall volume with the LEVEL control.
7
Adjust the sound with the controls HI (high frequencies) and LOW (low frequencies).
8
During operation, please make sure the speaker always sounds well. When distortions can be heard,
either the subsequent unit or the speaker is overloaded. Overloads can quickly lead to damage on both
devices. In order to avoid damage, please reduce the volume immediately when distortions can be
heard. When speakers are destroyed by overload, the guarantee becomes void. Always check the
sound pressure level with a meter in order to keep to the threshold.
9
After operation, switch off the speaker system with the power switch. The POWER indicator goes off.
17