Operation; Setting Up A Bluetooth Connection With Mobile Devices - Omnitronic ACS-410BTS Bedienungsanleitung

7

OPERATION

1
First turn down the MASTER control for the overall volume to the left stop position to avoid a possible
switching-on noise. Then switch on the PA system. The POWER indicator lights.
2
Use the input selector buttons to switch the mono channels CH 1 and 2 to microphone or line level
according to the signal sources connected.
3
Turn up the MASTER control so that the mixing ration of the signal sources can be adjusted in an
optimum way.
4
Adjust the desired volume ratio of the input channels with the LEVEL controls. Turn the controls of the
inputs not used to 0.
5
Adjust the desired sound of the mono channels CH 1 and 2 with the tone controls. By adjusting the tone
controls, the high frequencies (control HI) and the low frequencies (control LOW) can be boosted or
attenuated. With the controls in mid-position, the frequency response is not affected.
6
A reverb effect created via the integrated effect processor can be added to the mono channels CH 1
and 2. Switch on the effect with the corresponding button and adjust the effect intensity with the FX
LEVEL control.
7
Adjust the definite level of the overall volume with the MASTER control. Only turn up the control to such
an extent that the sound reproduction will not be distorted. The LIMIT indicator lights up when the signal
level is too high so that the level limitation will be activated. If this indicator lights up frequently, reduce
the master volume or the volume of the input signals accordingly.
8
After operation, set the MASTER control to minimum, then switch off the PA system with the power
switch. The power indicator extinguishes.

Setting up a Bluetooth Connection with Mobile Devices

The PA system features a Bluetooth receiver allowing you to stream music wirelessly from your mobile
devices such as smartphones, tablets and notebooks.
1
To activate the Bluetooth module press and hold the PAIR button for 3 seconds after switching on.
2
Shortly press the PAIR button again to enter the pairing mode.
3
Activate the Bluetooth function at the Bluetooth source and start the device scan. Select "
from the list and connect the devices.
4
The PAIR LED will flash while pairing. It will light solid when the Bluetooth source is paired. To reset
pairing press and hold the PAIR button for 3 seconds. NOTE: Initial pairing may take 60+ seconds.
5
Now play music at the Bluetooth source as you normally would and the sound will come out of the
speaker system. Mix the Bluetooth signal to the master signal using the level control in channel CH 5/6.
20
OMNITRONIC
"