Operation; Mixer Unit; Setting Up A Bluetooth Connection With Mobile Devices - Omnitronic WAMS-08BT MK2 Bedienungsanleitung

6 Operation

Mixer unit

1) Prior to switching on, turn down the master control MASTER LEVEL for the overall level to the left stop
position to avoid a possible switching-on noise.
2) First switch on the connected audio sources, then the PA system. The POWER indicator lights up green.
If it lights up red during battery operation, the battery should be recharged.
3) Adjust the master control to a level that the subsequent adjustments can be heard well via the PA
system.
4) Adjust the desired volume ratio of the signal sources with the level controls. Turn the controls of the
inputs not used to zero.
Notes
• Channel 3 works in parallel to the built-in audio player, which means the audio player signal can be
heard at the same time as audio coming in through the channel 3 connections.
• Do not direct any microphones to speakers. This can result in dangerous and unpleasant acoustic
feedback which will generate a loud whistling sound.
5) Optimize the sound of the mixed signal with the tone controls.
6) A reverb effect created via the integrated effect processor can be added to the microphone signals of
channels 1 and 2. Adjust the effect intensity with the ECHO control.
7) Determine the definite level for the master volume of the PA system with the master control. In case of
overload the red PEAK indicator lights up. If it lights continuously, turn back the master control
accordingly.
8) After operation, switch off the PA system first. The POWER indicator goes out. The automatic charging
for the rechargeable battery is always active even if the unit is switched off. To prevent unnecessary
power consumption, always disconnect the mains plug from the mains socket if the unit is not used for a
longer period.

Setting up a Bluetooth connection with mobile devices

The PA system features a Bluetooth receiver allowing you to stream music wirelessly from your mobile
devices such as smartphones, tablets and notebooks.
Bluetooth ON
1) Press the MODE button (repeatedly) until the display indicates "bLUE". The audio player will enter the
pairing mode.
2) Activate the Bluetooth function at the Bluetooth source. The PA system is indicated by "WAMS-08BT
MK2" on the display of the Bluetooth source. Pair the devices with each other.
3) Now play music at the Bluetooth source as you normally would and the sound will come out of the PA
system.
4) Use level control in channel 3 to adjust the volume.
5) The Bluetooth source may also be operated via the audio player. To interrupt or continue the playback,
press the button [► ]. With the buttons [
a
] and [
WAMS-08BT
b
] you can skip titles in forward or backward direction.
26 • EN
c