Operation - Omnitronic WAMS-08BT Bedienungsanleitung

9

OPERATION

1
Adjust the desired volume ratio of the input channels with the level controls. Turn the controls of the
inputs not used to 0.
Do not direct any microphones to speakers. This can result in dangerous and
unpleasant acoustic feedback which will generate a loud whistling sound.
2
Optimize the sound of the mixed signal with the tone controls for high and low frequencies.
3
In case of overload the PEAK indicator lights up. If the LED lights continuously, reduce the level of the
signal sources accordingly.
4
An echo effect created via the integrated effect processor can be added to the signal of the input
channels 1 and 2. Adjust the effect intensity with the control ECHO.
5
After operation, switch off the PA system. The power indicator extinguishes. Also, do not forget to
switch off the microphone. Otherwise the batteries will be exhausted the next time the microphone is
used.
Audio Player
The audio player can either be operated via the buttons on the front panel or via the remote control. When
actuating a button, always direct the remote control towards the sensor. There must be no obstacles
between remote control and the sensor. If the range of the remote control decreases, the battery is probably
exhausted and must be replaced.
1
Keep the button [STOP/POWER] pressed for two seconds to switch on the audio player. The display
shortly indicates a welcome screen "
carrier has been inserted.
2
Insert a USB device into the USB port and/or a memory card into the card slot. Shortly press the button
[MODE] to switch between the data carriers.
3
After loading a data carrier, it is selected as the playback medium and read in. The display indicates the
total number of titles and "
4
Start the playback with the button [PLAY/PAUSE] on the player or [► ] on the remote control. The
display indicates "► ". During the playback, the display indicates the elapsed time of the current title in
minutes and seconds. Additionally, the file name will be scrolling across the display.
5
Adjust the desired volume for the audio player with the level control [BLUETOOTH/MP3]. Alternatively,
you can use the buttons [V+] and [V-] on the player (long actuation) or [+] and [-] on the remote control.
CAUTION!
WELCOME, PLEASE WAIT...
PLEASE PUSH PLAY".
35
NO DISK
", "; then " " comes on if no data