Herunterladen Inhalt Inhalt Diese Seite drucken

Descaling The Appliance - Silvercrest SEM 1100 B3 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für SEM 1100 B3:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Descaling the appliance

Descale the appliance regularly. The appliance should be descaled after about
1- 2 months (at approx. 4 espresso preparations per day). Depending on the
hardness of the water in your area, this figure may differ.
For descaling, use a commercially available descaler for espresso machines.
Proceed as described in the instructions for usage of the descaler.
If you do not have any descaling products, you can use citric acid and proceed
as follows:
1) Fill the water tank 9 to the marking MAX.
2) Dissolve 2 tablespoons (about 30 grams) of citric acid (available in drugstores
or chemists) into the water.
3) Replace the water tank 9 into the appliance.
4) Switch on the appliance using the On/Off switch 1. The steam control 7
is closed.
5) Insert the sieve holder u without the espresso sieves i o back into the
appliance and place a cup under the sieve holder u.
6) As soon as the green heat-up indicator lamp 5 lights up, press the "Espresso"
button
7) Allow around 2 cups (approx. 250 ml) of water to run through and then stop
the process by pressing the "Espresso" button
8) Hold a container under the milk frother 0.
9) Press the "Steam" button
until the green heat-up indicator lamp 5 lights up. Slowly turn the steam
control 7 to the position " + ". Allow the appliance to create steam for
about 2 minutes.
10) After 2 minutes, close the steam control 7, then press the "Steam" button
again so that no more steam is generated.
11) Let the scaling agent take effect for about 15 minutes.
12) Repeat steps 6 - 11 three times.
13) Then press the "Espresso" button
run through until the water tank 9 is empty.
14) Rinse the water tank 9 with clean water and then fill it with clean water up
to the Max marking.
15) Press the "Espresso" button
until the green heat-up indicator lamp 5 lights up.
16) Allow the water to run through.
17) Repeat steps 14 - 16 three times.
18) Refill the water tank 9 with water.
SEM 1100 B3
3 so that it clicks in.
4 down so that it clicks into place and wait
3 down so that it clicks into place and wait
3 again.
3 down so that it clicks in, let the water
4
 43
GB

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ian 274989

Inhaltsverzeichnis