Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installing the USB-driver
*
Connect the delivered USB-interface cable to a free USB-port at
your PC and your PeakTech
*
After connection, windows will find new devices:
CP2101 USB to UART Bridge Controller
CP2101 USB Composite Device
*
Windows needs the corresponding USB-drivers to fulfil the
installation.
*
You will find the USB-drivers on the delivered software-cd
*
Follow the steps on screen
Installing the software
*
Start windows
*
Insert the CD into the CD/DVD-drive.
*
The CD provides with Auto-Start and run the installation program
automatically. If the Auto-Start doesn't run, execute the
Installation manual. START
your CD-ROM-drive)
*
Follow the steps on screen and finish the installation.
Potential malfunctions during humidity measuring:
*
Do not measure humidity under sun.
*
Do
not
measure
humidity
temperature or humidity.
*
Do not measure humidity in an environment with excessive
sands or dusts.
*
Humidity sensor should make no contact with water or
(dry humidity sensor with blow dryer immediately if it
a contact with water or liquid).
*
Do not take humidity in an environment with severe temperature
change.
®
5040.
Run
D:\SETUP.EXE (If D. is
in
extremely
high
has made
-26-
or
low
liquid
Werbung
