Specifications - Makita 6510LVR Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Low
1-2. High
1-3. Speed control screw

SPECIFICATIONS

Capacities
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for drilling in wood, metal and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Explanation of general view
1-4. Switch trigger
1-5. Lock button
2-1. Reversing switch lever
Model
Steel
Wood
-1
)
Overall length
Net weight
Safety class
) : 90 dB(A)
pA
) : 101 dB(A)
WA
2
) : 2.5 m/s or less
h,D
2
ENE032-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
ENF002-2
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
ENG905-1
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
ENG900-1
Drill
Model No./ Type: 6510LVR
are of series production and
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
ENG901-1
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd.
Michigan Drive, Tongwell,
Milton Keynes, Bucks MK15 8JD, England
3
3-1. Tighten
3-2. Sleeve
3-3. Ring
6510LVR
10 mm
18 mm
0 - 1,200
242 mm
1.4 kg
/II
Corporation as the
ENH101-15
responsible