The device must only be connected with an electric installation carried out in compliance with the IEC
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
5. OPERATION
Main display
Encoder +/-
change the view on the display, to see IP address, status, software version, etc
Press Encoder Enter the setup menu
Setup Menu
Encoder +/-
select one of the setup items:
-
Exit Setup
-
View DMX
-
Quick Setup
-
DMX port 1
-
DMX port 2
-
DMX port 3
-
DMX port 4
-
DMX port 5
-
DMX port 6
-
DMX port 7
-
DMX port 8
-
Network Options
-
Backlight
Press Encoder activate the selected option
DMX View menu
With this menu, you can visualize all the DMX channels going in or out of a DMX port.
In select mode:
Encoder +/-
select one of the options
- Set view mode
- Select one of the ports to view
- Back (go back to the setup menu)
120 bars
40 bars
decimal
precentage
14/16
00058403.DOC, Version 1.0