Operation; Master/Slave-Operation - EuroLite LED ARRAY Bedienungsanleitung

OPERATION

Connect the connection cables of the controller with the sockets of the LED luminaries. Connect the system
to the mains with the power-plug.
After you connected the effect to the mains, the EUROLITE LED ARRAY DMX Lighting Controller starts
running.
Selecting functions and parameters
Press the MODE button and select the desired function.
The desired parameter values can be selected via the SET UP, UP or DOWN buttons.
Speed, or intensity, of the desired parameter can be selected via the steps 0 – 255: 0 = off; 1 = slowest; 255
= fastest. The chosen step appears on the LCD display.
Parameter: Function:
MODE Blackout
Static
SET UP:
MODE MANUAL RGB
SET UP:
Red
Green
Blue
MODE RGB JUMP CHANGING
SET UP:
Interval
MODE FADE CHANGING
SET UP:
Speed
Interval
MODE AUTO PROGRAM
SET UP:
Auto jump
Auto fade
MODE ADDRESSING DMX 512
SET UP:
Channels

Master/Slave-Operation

The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the LED ARRAY DMX Lighting Controller you can find an XLR-jack (bottom) and an
XLR-plug (top), which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the OUT-jack with the IN-plug of the next device.
Static colors: red, green, blue,
purple, cyan, yellow, white
0 – 255
0 - 255
0 - 255
0 - 255
0 - 255
0 - 255
0 - 255
0 - 255
1 - 512
17/19 51913060_V_1_0.DOC