Operation; Manual-Mode; Unlock Program Mode; Switch The Dimmer Display - EuroLite KRX-16 Bedienungsanleitung

Building a serial DMX-chain:
Connect the DMX-output of the KRX-16 with the DMX-input of the nearest dimmerpack. Always connect one
output with the input of the next fixture until all fixtures are connected.
Occupation of the XLR-connection:
You can adjust the XLR polarity via the DMX POLARITY selector.
Ω
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120 resistor
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

6. OPERATION

After you connected the device to the mains, the KRX-16 is ready for use.

6.1 Manual-mode

In the Manual-mode (Manual-LED is lit), you can call up the individual channels manually and control them
via the channel faders. Please note that the adjusted settings cannot me memorized.
Press the Manual-button - the Manual-LED is lit.
Push Master-fader to maximum.
Push channel-faders to the desired setting.

6.2 Unlock program mode

Before you can start programming you need to unlock the program mode.
Press and hold the Step-button and Blackout-button.
Press the Program-button in order to select OFF.
Release the Program-button.
Release the Step-button and Blackout-button and the program mode is unlocked.

6.3 Switch the dimmer display

The dimmer display can be switched from percent to the DMX-value:
Press and hold the Pattern-buttons 5, 6, 7 and 8.
Switch the unit off and on again.
The Pattern-buttons 1, 2, 3 and 4 are lit. Press button 3 for percent or button 4 for DMX-value.
Press the Blackout-button twice in order to save the settings.

6.4 Memorize scenes

With the KRX-16 you can memorize up to 16 different scenes with 16 channels.
Press the Program-button and the Manual-button.
Press the desired Pattern-button where you would like to memorize the scene. The respective LED will
slowly flash.
Push the Master-fader to maximum.
Push channel-faders to the desired setting.
Press the Program-button.
Press the Blackout-button in order to memorize the scene.

6.5 Call up scenes

Press the Pattern-button where you memorized the desired scene.
Push the Master-fader to maximum.
The scene will be called up.

6.6 Memorize chasers

With the KRX-16 you can memorize 16 different chasers with up to 100 steps each.
Press the Program-button and the Manual-button.
Press the desired Pattern-button where you would like to memorize the chaser. The respective LED will
slowly flash.
Push the Master-fader to maximum.
19/35 70064620X74NXS_V_1_0.DOC