Operation; Cleaning And Maintenance; Replacing The Fuse; Technical Specifications - EuroLite ST-1 Bedienungsanleitung

OPERATION

Power: to switch the unit on and off.
Speed: to control the flash speed.

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuse-holder on the rear panel with a fitting screwdriver from the housing (anti-
clockwise).
Step 2: Remove the old fuse from the fuse-holder.
Step 3: Install the new fuse in the fuse-holder.
Step 4: Replace the fuse-holder in the housing and fix it.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
Output signal
Speed:
Maximum load:
Dimensions (WxDxH):
Weight:
Fuse:
Accessory:
OMNITRONIC Jack cable 6.3 mono 3m black
Please note: All information is subject to change without prior notice. 24.03.2017 ©
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
230 V AC, 50 Hz ~
20 W
0/10V impulses
30 - 360 flashes/min.
5 strobes
180 x 70 x 60 mm
0.6 kg
F 0,5 A, 250 V
No.
3021050N
11/11 00107786, Version 1.4