Working Instructions; Putting Into Operation - Bosch GCM 10 S PROFESSIONAL Bedienungsanleitung

Variable Horizontal Mitre Angle
The horizontal mitre angle can be set in the range from
45° (left side) to 60° (right side).
Place the machine in the working position.
Loosen the locking knob 13 in case it is tightened.
Pull the lever 14 and press the locking clamp 12 at the
same time until it engages in the groove provide for this
purpose (see the illustration
saw table becomes freely moveable.
Rotate the saw table 17 to the left or right until the an
gle indicator 15 points to the desired mitre angle.
Retighten the locking knob 13 .
Standard Vertical Bevel Angles
(see Figure )
K
The standard angles of 0° and 45° are each provided
by factory adjusted end stops. A fixed angle setting for
the angle 33.9° is also possible.
Place the machine in the working position.
Loosen the clamping handle 34.
Swing the tool arm with the handle 6 until the tool arm
rests on the stop screw 24 (0°) or 23 (45°).
Retighten the clamping handle 34.
For the standard angle of 33.9°, pull the setting knob
33 completely out and turn by 90°. Then swing the
tool arm with the handle 6 until the tool arm audibly en
gages.
Variable Vertical Bevel Angle
(see Figure )
L
The vertical bevel angle can be set in the range from
0° to 45°.
Loosen the clamping handle 34.
Swing the tool arm with the handle 6 until the angle in
dicator 45 points to the desired bevel angle.
Hold the tool arm in this position and retighten the
clamping handle 34.

Putting into Operation

Switching On and Off
To put into operation, pull the on/off switch 5 in the
direction of the handle 6.
For safety reasons, the on/off switch of the ma
chine cannot be locked on but must remain de
pressed during operation.
For sawing, press in addition the locking lever 4. (see
the Figure
M
)
Only by pressing the locking lever can the tool arm be
guided downward.
To switch off the machine, release the on/off switch
5.
1 609 929 E49 • (03.09) PS
). In this manner, the
J
English–8
0 601 B20 537 (Australia)
To put into operation, slide the switch lock in the di
rection of the tool arm. Then press the on/off switch 5
and hold it depressed.
For safety reasons, the on/off switch of the ma
chine cannot be locked on but must remain de
pressed during operation.
To switch off the machine, release the on/off switch
5.

Working Instructions

Before all work on the machine, pull the mains
plug.
General Sawing Instruction
For all cuts, it must first be ensured that
the saw blade at no time can come in con
tact with the fence, screw clamp or other
machine parts. Remove possible interfer
ing auxiliary stops or adjust them accord
ingly.
Do not load the machine so heavily that it comes to a
standstill.
Advancing that is too fast reduces considerably the
performance capability of the electro tool and reduces
the service life of the saw blade.
Use only sharp saw blades that are suitable for the ma
terial being worked.
Hand Positioning
Keep fingers, hands and arms away from the rotating
saw blade. (see Figure
Do not cross your arms when operating the tool arm.
(see Figure )
O
Maximum Work Piece Dimensions
Sawing Angle
Mitre Bevel
(Horizontal) (Vertical)
0°
45°
0°
45°
)
N
Height x Width [mm]
0° 87 x 305
0° 87 x 216
45° 53 x 305
45° 53 x 216