Troubleshooting; Warranty - Kärcher HD 10/16-4 Cage Bedienungsanleitung

Troubleshooting

You can rectify minor faults yourself with
the help of the following overview.
If in doubt, please consult the authorized
customer service.
DANGER
Risk of injury!
Always switch off the appliance and pull out
the mains plug before care and mainte-
nance work.
WARNING
Repair work and work on electrical compo-
nents may only be performed by the author-
ized customer service in non-explosion
danger areas.
Appliance is not running
– No power
 Check the plugs and sockets.
 Check whether the voltage indicated on
the type plate corresponds to the volt-
age of the socket.
 Check the mains connection cable for
damages.
– Engine is overheated
 Switch off appliance and let it cool
down. Remove the cause of the prob-
lem. Turn on the appliance again.
Device is not building up pressure
– Wrong nozzle
 Check nozzle for correct size (see tech-
nical specifications).
– Air within the system
Vent pump:
 Unscrew the nozzle. Switch on the ap-
pliance and let it run until the water ex-
iting from the spray pipe is bubble-free.
Switch off the appliance and fit the noz-
zle again.
– Nozzle is blocked/ washed out
 Clean/ replace nozzle.
– Filter at the water connection is dirty
 Clean filter at the water connection.
– Amount of water supply is too low.
 Check water supply level (refer to tech-
nical data).
– Pipe inlets to pump are leaky or blocked
22
 Check all supply lines to the high-pres-
sure pump for leaks or blockages.
High pressure side is leaky
 3 drops per minute are permitted and
can come out from the lower side of the
appliance. Call Customer Service if
there is heavy leakage.
High pressure pump is vibrating
– Pipe inlets to pump are leaky or blocked
 Check all supply lines to the high-pres-
sure pump for leaks or blockages.
– Air within the system
Vent pump:
 Unscrew the nozzle. Switch on the ap-
pliance and let it run until the water ex-
iting from the spray pipe is bubble-free.
Switch off the appliance and fit the noz-
zle again.
Water jet is not uniform
– Amount of water supply is too low.
 Check water supply level (refer to tech-
nical data).
Device is not sucking in detergent
– Incorrect nozzle inserted.
 Replace the high-pressure nozzle with
the low-pressure nozzle.
– Filter at the detergent suction hose dirty
 Clean filter.
– Backflow valve stuck
 Remove the detergent hose and loosen
the backflow valve using a blunt object.
– Detergent container is empty
 Fill/replace detergent container.
– The warranty terms published by our
competent sales company are applica-
ble in each country. We will repair po-
tential failures of the appliance within
the warranty period free of charge, pro-
vided that such failure is caused by
faulty material or defects in fabrication.
– The warranty comes only into effect if
your vender fills out the supplied reply
card completely at purchase, stamps
– 8
EN

Warranty