Care And Maintenance - Kärcher HD 10/16-4 Cage Bedienungsanleitung

Flush device with anti-freeze agent
Note:
Observe handling instructions of the anti-
freeze agent manufacturer.
 Pump in conventional frost protection
agents through the appliance.
A certain corrosion protection is achieved
with this as well.

Care and maintenance

DANGER
Risk of injury!
Always switch off the appliance and pull out
the mains plug before care and mainte-
nance work.
Safety inspection/ maintenance
contract
You can sign with your dealer a contract for
regular safety inspection or even sign a
maintenance contract.
Please take advice on this matter.
Maintenance intervals
Daily
 Check oil level of the high pressure
pump.
The oil level must be between the "MIN"
and "MAX" markings on the oil contain-
er.
 Add oil if required (see technical speci-
fications).
ATTENTION
Risk of damage! In case of lacteous oil in-
form Kärcher customer service immediate-
ly.
Weekly or after 40 operating hours
 Clean filter at the water connection.
 Clean filter at the detergent suck hose.
 Check the swimmer valve in the swim-
mer container for leaks.
After 50 operating hours
 Change the oil in the high pressure
pump.
Every 500 operating hours, at least
annually
 Have the maintenance of the device
performed by the customer service.
 Change the oil in the high pressure
pump.
Maintenance Works
Clean filter at the water connection
 Unscrew the filter casing, remove the
filter, clean it and replace it.
Clean filter at the detergent suck hose
 Take out detergent suck hose.
 Clean filter in water and reinstall.
Oil change
 For oil type refer to technical specifica-
tions.
 Turn out the oil drain screw.
 Drain the oil in a collection basin.
 Screw in oil drain plug.
 Slowly fill in new oil until the "MAX"
marking on the oil container.
Note:
Air pockets must be able to leak out.
Dispose of old oil ecologically or turn in at
a gathering point.
Maintenance schedule
Wear parts
High-pressure/low-pres-
sure seals
Suction/pressure valves
O-rings/support rings of the
overflow valve
Ball bearing of the pump
gear
Oil races, shaft seal
– 7
EN
Operating
hours
1000 h
1000 h
1000 h
2000 h
2000 h
21