Colour Coding; Proper Use; Symbols On The Machine; Safety Instructions - Kärcher HD 10/16-4 Cage Bedienungsanleitung

20 Power cable with plug
21 Electro motor
22 Power switch
23 Low power nozzle
24 Union joint
25 High pressure nozzle
26 Spray lance EASY!Lock

Colour coding

– The operating elements for the cleaning
process are yellow.
– The controls for the maintenance and
service are light gray.

Proper use

The appliance was developped specifically
for working in areas with risks of explosion
(zone 1 and zone 2).
Use this high pressure cleaner exclusively
for:
– to clean machines, vehicles, buildings,
containers and tools, which are exclu-
sively permitted for cleaning using a
high-pressure cleaner.
– with accessories and spare parts ap-
proved by Kärcher.
– It is wrong and therefore prohibited is
the cleaning of humans and animals.
There is a high risk of injury due to the
high pressure jet.
– It is wrong and therefore prohibited is
cleaning loose parts. These can get
thrown off due to the high pressure jet
and can cause damage to persons or
other parts of the plant.
– The appliance should only be operated
with water.
– If water is used for cleaning, protect the
appliance from frost to prevent damag-
es by freezing water.
Quality requirements for water:
ATTENTION
Only clean water may be used as high
pressure medium. Impurities will lead to in-
creased wear and tear or formation of de-
posits in the appliance.
If recycled water is used, the following limit
values must not be exceeded.
16
pH value
electrical conductivity *
settleable solids **
total suspended solids *** < 50 mg/l
Hydrocarbons
Chloride
Sulphate
Calcium
Total hardness
Iron
Manganese
Copper
Active chloride
free of bad odours
* Maximum total 2000 µS/cm
** Test volume 1 l, settling time 30 min
*** no abrasive substances

Symbols on the machine

High-pressure jets can be dan-
gerous if improperly used. The
jet may not be directed at persons, animals,
live electrical equipment or at the appliance
itself.

Safety instructions

– Please follow the national rules and
regulations for fluid spray jets of the re-
spective country.
– Please follow the national rules and
regulations for accident prevention of
the respective country. Fluid spray jets
must be tested regularly and the results
of these tests must be documented in
writing.
– The appliance/accessories must not be
modified.
– 2
EN
6,5...9,5
Conductivity
fresh water
+1200 µS/cm
< 0,5 mg/l
< 20 mg/l
< 300 mg/l
< 240 mg/l
< 200 mg/l
< 28 °dH
< 50 °TH
< 500 ppm
(mg CaCO /l)
3
< 0,5 mg/l
< 0,05 mg/l
< 2 mg/l
< 0,3 mg/l