Initial Settings - Hama EWS-830 Bedienungsanleitung

Note
• The wireless transmission range between the measuring and base stations is up to 30 m in open spaces.
• Before installation, ensure that wireless transmission will not be disrupted by interference or obstacles
like buildings, trees, vehicles, high-voltage lines, etc.
• Before the final installation, ensure that there is sufficient reception between the intended installation
locations.
• When installing the measuring station, ensure that it is protected from direct sunlight and rain.
• The international standard height for measuring air temperature is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material from a specialised dealer for wall-mounting.
• Ensure that no faulty or damaged parts are installed.
• Never apply force during installation. This could damage the product.
• Before installation, ensure that the chosen wall is suitable for the weight to be mounted, and make sure
that there are no electrical wires, water, gas or other lines at the installation site on the wall.
5.1. Base station
• Use the base to position the base station on a level surface.
5.2. Measuring station
• You can also position the measuring station on a level outdoor surface.
• We recommend installing the measuring station securely on an outdoor wall using the opening (44).
• Install an anchor, screw, nail, etc. in the wall of your choice.
• Hang up the base/measuring station using the opening intended for this purpose.
6. Operation
Note – Input
Hold down the button (36) or the
+

6.1. Initial settings

• After inserting the batteries, a value indicating the height in metres (4) will flash.
• Set the following information in the order listed:
• height of the location, symbol for the current weather conditions, atmospheric pressure unit (hPa/ inhg)
• To select the individual values, press the + button (36) or the – button (37) and confirm each selection by
pressing the HISTORY button (38). .
• The standard settings are retained if you do not make an entry within 20 seconds. You can subsequently
change/reset these values at any time as described in 6.4. Basic and manual settings.
button (37) to select the values faster.
–
5