LEXIBOOK MeteoClock Elegance Bedienungsanleitung Seite 8

MAXIMUM/MINIMUM TEMPERATURE/HUMIDITY RECORDING FUNCTION
This weather station records everyday the maximum/minimum indoor /outdoor temperature and
indoor humidity level. The readings are automatically cleared daily at 00:00.
1. Press [B5] once to see the maximum indoor temperature [A5], outdoor temperature [A9] and indoor
humidity [A4]. "MAX" is shown at [A3] and [A6].
2. Press [B5] twice to see the minimum indoor [A5] and outdoor temperature [A9]. "MIN" is shown
at [A3] and [A6].
3. Press and hold [B5] to clear the recorded temperature and humidity readings.
Moon phases
Throughout the 28 days of the lunar month, the aspect of the moon changes. Indeed, the moon, being
spherical, is always half lightened up by the sun. As the moon rotates around the Earth, the
appearance of its lightened side changes continuously. This phenomenon creates moon phases. The
moon phase [A14] on your MeteoClock® is automatically updated according to the year / month / day.
1: New Moon 2: Waxing Crescent 3: First Quarter 4: Waxing Gibbous
5: Full Moon 6: Waning Gibbous 7: Last Quarter 8: Waning Crescent
Tides
Every 12 hours approximately, the oceans on each side of the planet rise slightly then fall back. This
movement is called tides. It is the result of the gravitational pull of the moon and the sun and the
rotations of the earth, moon and sun. Your weather station displays the tide status [A14] as follows:
H: High Tide M: Medium Tide
Copyright © Lexibook 2008
FURTHER INSTRUCTIONS FOR MULTI-SENSOR USE
If you have one or two additional sensors, you can place them in a different location in your house; in
a bedroom, for example. Your main unit can collect the temperature and humidity data of up to three
remote sensors.
Set up:
To set up a new sensor, follow the instructions given on page 5. Make sure you set every sensor to a
different channel.
Temperature and humidity and display :
You can view the humidity and temperature readings of your different remote sensors by pressing the
[B2] key. The sequence is as follows:
The sign ' ' [A8] means that the unit will display your available channels consecutively. Press and
hold [B2] to remove a channel manually. It will automatically search and register new channel again if
a new channel is received. If no temperature is displayed on an existing channel ( " - - . –" is
displayed on the LCD ), press and hold [B2] to cancel that channel and receive the channel again.
Then, press [D3] on the corresponding sensor unit to transmit the signal to the main unit manually.
Additional sensors:
Measure temperature and hygrometry in other places!
- Upstairs
- In the baby's bedroom
- In the basement
- In the wine cellar
- In another room
To order, phone the Lexibook office located in your country or browse www.lexibook.com
12
MOON PHASES & TIDES
L: Low Tide
ACCESSORIES
Copyright © Lexibook 2008
11