Herunterladen Inhalt Inhalt Diese Seite drucken

Hama EWS-Trio Bedienungsanleitung Seite 7

Vorschau ausblenden Andere Handbücher für EWS-Trio:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 9
Celsius / Fahrenheit
• Press the DOWN button (13) to switch between °C and °F
for the temperature display.
6.3 Alarm
Alarm mode AL is displayed between the hours and minutes
of the time display.
• Press the ALARM button (8) once to call up alarm mode.
• Press and hold the ALARM button (8) for approximately
3 seconds to set the alarm time. The hours display begins
to flash.
• Press the UP button (12) or the DOWN button (13)
to select the hour for the alarm time and confirm your
selection by pressing the ALARM button (8). The minutes
display begins to flash.
• Repeat the process to set the minutes for the alarm time.
• If you do not make an entry for approximately 5 seconds,
you automatically exit the setting mode.
• Press the DOWN button (13) to activate or deactivate
the alarm. An active alarm is displayed by the alarm
symbol ( ). The alarm symbol goes out when the alarm
is deactivated.
• If the alarm is triggered, the alarm symbol ( ) will begin
to flash and an alarm will sound.
• Press any button (except the SNZ/LIGHT button (10)) to
stop the alarm. Otherwise, it will stop automatically after
2 minutes.
Note – Snooze function
• While the alarm signal is sounding, press the SNZ/
LIGHT button (10) to activate the snooze function. The
alarm symbol ( ) will start to flash on the display. The
alarm signal will stop for 5 minutes, after which it will
sound again.
• Press any button (except the SNZ/LIGHT button) to
stop the snooze function and the alarm.
6
6.4 Maximum and minimum temperature and
humidity values
The base station automatically stores the maximum and
minimum outdoor/indoor temperature and humidity values.
• Repeatedly press the UP button (12) to switch the
display between the current temperature and humidity,
maximum temperature and humidity (MAX) and minimum
temperature and humidity (MIN).
6.5 Backlight
• Press the SNZ/LIGHT button (10) to light up the display
for approximately 5 seconds.
7. Care and Maintenance
• Only clean this product with a slightly damp, lint-free cloth
and do not use aggressive cleaning agents.
• Make sure that water does not get into the product.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
9. Service and Support
Please contact Hama Product Consulting if you have any
questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

00136293

Inhaltsverzeichnis