teutonia spirit Bedienungsanleitung Seite 10

INT SPIRIT
Removing the tilting unit
Tilting wheel
Tilting wheel locked
We recommend that you do not lock the wheels when
pushing the buggy in order to increase the comfort.
Seat cover
The seat cover can be completely removed from the seat
unit in order to be washed. To do this, press the press
studs on the seat unit.
The middle seat or reclining surface is designed as a
two-way seat. Release the side zips, pull the cover over
at the head end and the belt on the other side and
re- attach the centre piece on the sides.
Attention: When fitting the seat cover, please pull the
end of the 5-point harness back through the matching
openings without twisting it.
Height-Adjustable, Foldable Handle
10
Press locking spring 1, hold
and remove the complete
tilting unit 2.
Take care during assembly
that the locking spring locks
properly.
Tilting wheel released
To change the height of the
handle, press in the adjusting
buttons on both sides of the
handle.
Applying the Parking Brake
wheel rim. Make sure that the brake has locked secure-
ly. You can release the brake by depressing the brake
lever 2.
Attaching and removing the hood and/or cot
Place the top part on the frame in such a way that the bar
1 on each side of the base clicks into the correct slots 2.
Then slide the top part to the block. The catches then
lock automatically (the catch must "click").
Warning:
Before use, please check that the attachment and
seating unit are correctly clicked into place. The top part
is secure when the red area on the release mechanism
can no longer be seen. To remove the top part, push the
release lever 3 downwards until the lever locks (red area
is visible). Then pull the top part out of the slots and
remove it.
How to use the hood
Push the insert pieces for the hood joints into the cor-
responding openings on the armrest or on the carry-cot.
Attention: You must secure the press studs on the back
end of the cover onto the rear of the backrest as the co-
ver is also used as a protection against falling out.
If you need to remove the hood, undo the press studs on
the rear of the backrest; press the release buttons on the
insert pieces of the hood joints and pull the joints out of
the openings. You can open the zip at the top of the hood
for ventilation.
The brake is activated by
pushing down the long brake
lever 1. If it is difficult to
apply the brake, wheel the
stroller back and forth a few
centimetres so that the brake
bars engage properly in the