elco THISION S PLUS Compact V Betriebsanleitung Seite 50

Display of information
Manual operation
Chimney sweep function
Display of information
The information button can be used for
displaying different information.
Possible information values
Depending on the type of facility,
its configuration and the operating
condition, individual lines of information
may not be visible.
Error message
- Maintenance report
- Room temperature
- Room temperature minimum
- Room temperature maximum
- Boiler temperature
- Outdoor temperature
- Outdoor temperature minimum
- Outdoor temperature maximum
10
AUTO
Raumtemperatur
0 4 8 12 16
Manual operation
When the facility is operated in manual
mode, the relay output pins are no
longer switched according to the
standard control condition. Instead,
their function is set to a pre-defined
manual operation condition.
Target value settings for manual
operation
After the manual mode has been
activated, the system must be changed
to default display. There the symbol for
maintenance/special operations mode
will be displayed.
In the boiler menu, the target value for
manual mode operations can be set in
parameter line 2214.
- DHW temperature 1
- Boiler status
- DHW status
- Heating circuit status 1/2
- Time / date
- Customer service telephone
20 24
The boiler, mixer circuit, supply and
drink water pumps are set to ON; the
storage pump is set to OFF.
The switching valve is set to heating
mode, while the mixer is set to half of
its average value.
Chimney sweep function
The chimney sweep function is
activated through a short pushing of
the corresponding button.
The chimney sweep function will put
the facility into the required operating
condition, for measuring emissions
(waste gas).
May only be operated by the
chimney sweep!